Guide contents
Controllable Branch Parent
Native property registrations from the pinned engine; not certification of this equipment. Use native IDs and inspect actual object state. Absence is not zero. Definitions/units/types below are exact source declarations, not guessed conversions. See Projects.
R
Total positive sequence resistance.
Unit: p.u. Type: float Profile: none declared
X
Total positive sequence reactance.
Unit: p.u. Type: float Profile: none declared
G
Total positive sequence shunt conductance.
Unit: p.u. Type: float Profile: none declared
B
Total positive sequence shunt susceptance.
Unit: p.u. Type: float Profile: none declared
R0
Total zero sequence resistance.
Unit: p.u. Type: float Profile: none declared
X0
Total zero sequence reactance.
Unit: p.u. Type: float Profile: none declared
G0
Total zero sequence shunt conductance.
Unit: p.u. Type: float Profile: none declared
B0
Total zero sequence shunt susceptance.
Unit: p.u. Type: float Profile: none declared
R2
Total negative sequence resistance.
Unit: p.u. Type: float Profile: none declared
X2
Total negative sequence reactance.
Unit: p.u. Type: float Profile: none declared
G2
Total negative sequence shunt conductance.
Unit: p.u. Type: float Profile: none declared
B2
Total negative sequence shunt susceptance.
Unit: p.u. Type: float Profile: none declared
tolerance
Tolerance expected for the impedance values% is expected for transformers0% for lines.
Unit: % Type: float Profile: none declared
tap_changer
Tap changer object
Unit: not declared Type: SubObjectType.TapChanger Profile: none declared
tap_module
Tap changer module, it a value close to 1.0
Unit: not declared Type: float Profile: tap_module_prof
tap_module_max
Tap changer module max value
Unit: not declared Type: float Profile: none declared
tap_module_min
Tap changer module min value
Unit: not declared Type: float Profile: none declared
tap_module_control_mode
Control available with the tap module
Unit: not declared Type: TapModuleControl Profile: tap_module_control_mode_prof
vset
Objective voltage at the "to" side of the bus when regulating the tap.
Unit: p.u. Type: float Profile: vset_prof
Qset
Objective power at the selected side.
Unit: MVAr Type: float Profile: Qset_prof
regulation_bus
Bus where the regulation is applied.
Unit: not declared Type: DeviceType.BusDevice Profile: none declared
tap_phase
Angle shift of the tap changer.
Unit: rad Type: float Profile: tap_phase_prof
tap_phase_max
Max angle.
Unit: rad Type: float Profile: none declared
tap_phase_min
Min angle.
Unit: rad Type: float Profile: none declared
tap_phase_control_mode
Control available with the tap angle
Unit: not declared Type: TapPhaseControl Profile: tap_phase_control_mode_prof
Pset
Objective power at the selected side.
Unit: MW Type: float Profile: Pset_prof